Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 57
The default modes are listed in Table 6. All channel groups on a port must either be
all access or all network channel groups; there cannot be a mix. When the first
channel group is configured, all other channel groups on that port must be set to the
same mode. To change modes, all channel groups must first be shut down.
Table 6 Default Port Mode per Adapter Card, Module, or Platform
Default Mode Adapter Card, Module, or Platform
Network 2-port 10GigE (Ethernet) Adapter card
2-port 10GigE (Ethernet) module
6-port DSL Combination module
8-port xDSL module
10-port 1GigE/1-port 10GigE X-Adapter card
GPON module
To Next Page
Loading...
