Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 621
Phys State Chng Cnt The physical state change counter. This counter
increments when a fully qualified (debounced) transition
occurs at the physical layer of an Ethernet port, including
the following transitions of the port state as displayed in the
show port slot/mda/port output:
• from Down to Link Up or Up
• from Link Up or Up to Down
This counter does not increment for changes only in the link
protocol states. That is, if the physical link is up, any
transitions of the port state due to link protocols (for
example, 802.3ah EFM OAM, LACP, 802.1ag) do not
cause the counter to increment. The following port state
transitions are examples of transitions that are not counted:
• from Link Up to Up
• from Up to Link Up
Configured Mode network: the port is configured for transport network use
access: the port is configured for service access
hybrid: the port is configured for hybrid use (transport
network and service access per VLAN)
Dot1Q Ethertype The Ethertype expected when the port's encapsulation
type is dot1q
QinQ Ethertype The Ethertype expected when the port's encapsulation
type is qinq
Ing. Pool % Rate The amount of ingress buffer space, expressed as a
percentage of the available buffer space, that will be
allocated to the port or channel for ingress buffering
Net. Egr. Queue Pol default: the default policy is used
network: the network egress queue policy is used
Egr. Sched. Pol The egress scheduling policy
Net. Egr. ShaperPol The network egress shaper policy ID
Acc. Egr. ShaperPol The access egress shaper policy ID
Net. Scheduler Mode The network scheduler mode
Auto-negotiate true: the link attempts to automatically negotiate the link
speed and duplex parameters
false: the duplex and speed values are used for the link
Table 58 Show Specific Port Output Fields (GigE Port with Optical SFP)
Label Description
To Next Page
Loading...
