7705 SAR Interfaces
622
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Config Phy-tx-clock The mode used to establish timing control of a 1000Base-T
port. The options are:
• N/A— the port does not support 1000Base-T
• auto-pref-master—prefers to be master during
autonegotiation
• auto-pref-slave—prefers to be slave during
autonegotiation
• slave—the port is forced to be slave
• master—the port is forced to be master
Oper Phy-tx-clock The operational value of the MASTER-SLAVE relationship
of the 1000Base-T physical layer transmit clock. The
options are:
• N/A— the port or the inserted SFP does not support
1000Base-T, the port is down, or negotiation failed
• slave—the port is slave
• master—the port is master
SapEgr.Shaper Pol The SAP egress shaper policy for the port
SapEgr.Unshaped-Cir The CIR rate for the aggregate of all the unshaped
4-priority SAPs on the port
NetEgr.Unshaped-Cir The CIR rate for the aggregate of all the unshaped VLANs
on the port
Allow Eth-BN Indicates whether Ethernet Bandwidth Notification (ETH-
BN) is allowed on the port: True or False
BN Egr.Rate in use The egress rate in use based on the request from the ETH-
BN server MEP
Eth-BN hold time The configured hold time (in seconds) between an egress
rate change based on a received Bandwidth Notification
Message (BNM) and the next change request that will be
accepted
Egress Rate The maximum amount of egress bandwidth (in kilobits per
second) that this Ethernet interface can generate
Egr.Rate Incl.FCS The configured state of egress rate FCS inclusion: enabled
or disabled
Ingress CBS (bytes) Indicates the ingress committed buffer space
Src-pause A notification to slow down the transmission rate when it
exceeds the bandwidth limit
Table 58 Show Specific Port Output Fields (GigE Port with Optical SFP)
Label Description
To Next Page
Loading...
