Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 623
LACP Tunnel Indicates whether LACP packet tunneling is enabled
Down-when-looped Enabled: The down-when-looped feature is enabled on the
port
Disabled: The down-when-looped feature is disabled on
the port
Keep-alive The time interval between keepalive PDUs transmitted
toward the network during loop detection by the
down-when-looped feature
Loop Detected Indicates whether a loop is detected on the port
Retry The minimum wait time before the port is re-enabled after
it is brought down due to a loop detection
Use Broadcast Addr Indicates whether the down-when-looped feature has been
configured to compare the destination MAC address of
received PDUs to the broadcast MAC address instead of
the MAC address of the port
Loopback The type of loopback configured on the port, either line,
internal, or none
Swap Mac Addr Indicates whether MAC address swapping is enabled
Loopback Time Left The number of seconds left in a timed loopback
If there is no loopback configured or the configured
loopback is latched, the value is unspecified
If configured loopback is persistent, the value persistent.
Cfm Loopback Indicates whether the CFM loopback is enabled
Sync. Status Msg. Indicates whether Synchronization Status Messaging is
enabled on the port
PTP Asymmetry Indicates whether PTP asymmetry is enabled
Edge Timestamp Indicates whether the edge timestamp is enabled
Timestamp Capable Indicates whether the port is timestamp-capable
CRC Mon SD Thresh Indicates the CRC signal degrade threshold value (1 to 9),
if enabled
CRC Mon SF Thresh Indicates the CRC signal fail threshold value (1 to 9), if
enabled
CRC Mon Window Indicates the CRC window sampling size value (5 to 60)
Table 58 Show Specific Port Output Fields (GigE Port with Optical SFP)
Label Description
To Next Page
Loading...
