7705 SAR Interfaces
624
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Rx Quality Level The Synchronization Status Messaging quality level value
received on the port
Code-Type The Synchronization Status Messaging quality level code
type
Tx Quality Level The Synchronization Status Messaging quality level value
transmitted on the port
Tx DUS/DNU Indicates whether the transmission of the QL-DUS/DNU
value in synchronization status messages is enabled or
disabled on the port
Configured Address The base chassis Ethernet MAC address
Hardware Address The interface hardware- or system-assigned MAC address
at its protocol sublayer
Cfg Alarm The type of alarms to be logged and reported for the
Ethernet port
Alarm Status The current alarm state
Oper Speed The operating speed of the interface
Config Speed The configured speed of the interface
Oper Duplex full: the link is operating at full-duplex mode
half: the link is operating at half-duplex mode
Config Duplex full: the link is set at full-duplex mode
half: the link is set at half-duplex mode
MTU The size of the largest packet that can be sent/received on
the Ethernet physical interface, specified in octets
Hold time up The link-up dampening time in seconds
Hold time down The link-down dampening time in seconds
Encap Type null: ingress frames will not use any tags or labels to
delineate a service
dot1q: ingress frames carry 802.1Q tags, where each tag
signifies a different service
qinq: ingress frames carry two 802.1Q tags, where the
outer tag is the service provider tag and the inner tag is the
customer service tag
Table 58 Show Specific Port Output Fields (GigE Port with Optical SFP)
Label Description
To Next Page
Loading...
