Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 635
Retry The minimum wait time before the port is re-enabled after
it is brought down due to a loop detection
Use Broadcast Addr Indicates whether the down-when-looped feature has
been configured to compare the destination MAC
address of received PDUs to the broadcast MAC address
instead of the MAC address of the port
Loopback The type of loopback configured on the port, either line,
internal, or none
Swap Mac Addr. Indicates whether MAC address swapping is enabled
Loopback Time Left The number of seconds left in a timed loopback
If there is no loopback configured or the configured
loopback is latched, the value is unspecified.
If configured loopback is persistent, the value persistent
Cfm Loopback Indicates whether the CFM loopback is enabled
PoE Mode Indicates whether the port is using Poe, PoE+, or if the
PoE function is turned off (disabled)
PoE Detection Indicates the detection state of the PoE port
PoE Class Displays the class of the PoE device connected to the
port, as defined in IEEE 802.3af
PoE Fault Reason Displays the reason the PoE port is down if a fault is
detected
PoE Maximum Power Indicates the maximum amount of PoE power configured
and available on the port
PoE Power in Use Indicates the amount of PoE power being used by the
port
Sync. Status Msg. Indicates whether Synchronization Status Messaging is
enabled on the port
Rx Quality Level The Synchronization Status Messaging quality level
value received on the port
PTP Asymmetry Indicates whether PTP asymmetry is enabled
Edge Timestamp Indicates whether the edge timestamp is enabled
Timestamp Capable Indicates whether the port is timestamp-capable
Table 59 Show PoE Port Output Fields (Ethernet) (Continued)
Label Description
To Next Page
Loading...
