Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 659
Ethernet Output Example (access mode)
*A:ALU-1># show port 1/5/8 detail
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100/Gig Ethernet SFP
Interface : 1/5/8 Oper Speed : 1 Gbps
Link-level : Ethernet Config Speed : 1 Gbps
Admin State : up Oper Duplex : full
Oper State : up Config Duplex : full
Physical Link : Yes MTU : 1518
Single Fiber Mode : No
IfIndex : 44302336 Hold time up : 0 seconds
Last State Change : 10/04/2011 14:05:25 Hold time down : 0 seconds
Last Cleared Time : 10/04/2011 14:04:37 DDM Events : Enabled
Phys State Chng Cnt: 3
Configured Mode : access Encap Type : 802.1q
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100
Net. Egr. Queue Pol: default
Auto-negotiate : true MDI/MDX : MDX
Net. Scheduler Mode: 16-priority
Config Phy-tx-clock: auto-pref-slave Oper Phy-tx-clock: slave
SapEgr.Unshaped-Cir: 0 Kbps
SapEgr.Shaper-Pol : EgrShprPolicy
NetEgr.Unshaped-Cir: 0 Kbps
Allow Eth-BN : True
BN Egr.Rate in use : 765000 Eth-BN hold time : 6
Egress Rate : 1111 Ingress Rate : n/a
Egr.Rate Incl.FCS : Disabled
Ingress CBS(bytes) : 130816 Src-pause : Disabled
LACP Tunnel : Disabled
Down-when-looped : Disabled Keep-alive : 10
Loop Detected : False Retry : 120
Use Broadcast Addr : False
Loopback : none Swap Mac Addr : Disabled
Loopback Time Left : unspecified
Cfm Loopback : Disabled
Unknown proto discards
Input/Output
For packet-oriented interfaces, the number of packets
received at the interface that were discarded because of an
unknown or unsupported protocol. For character-oriented or
fixed-length interfaces that support protocol multiplexing, the
number of transmission units received at the interface that
were discarded because of an unknown or unsupported
protocol. For any interface that does not support protocol
multiplexing, this counter will always be 0.
Table 66 Show Port Detail Output Fields (SONET/SDH Port) (Continued)
Label Description
To Next Page
Loading...
