7705 SAR Interfaces
664
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
SapEgr.Unshaped-Cir The CIR rate for the aggregate of all the unshaped 4-
priority SAPs on the port
SapEgr.Shaper-Pol The access egress shaper policy ID
NetEgr.Unshaped-Cir The CIR rate for the aggregate of all the unshaped
VLANs on the port
NetEgr. Shaper-Pol The network egress shaper policy ID
Allow Eth-BN Indicates whether Ethernet Bandwidth Notification (ETH-
BN) is allowed on the port: True or False
BN Egr.Rate in use The egress rate in use based on the request from the
ETH-BN server MEP
Eth-BN hold time The configured hold time (in seconds) between an egress
rate change based on a received Bandwidth Notification
Message (BNM) and the next change request that will be
accepted
Egress Rate The maximum amount of egress bandwidth (in kilobits
per second) that this Ethernet interface can generate
Ingress Rate The maximum amount of ingress bandwidth (in kilobits
per second) that this Ethernet interface can generate
Egr.Rate Incl.FCS The configured state of egress rate FCS inclusion:
enabled or disabled
LACP Tunnel Indicates whether LACP packet tunneling is enabled
Down-when-looped Enabled: The down-when-looped feature is enabled on
the port
Disabled: The down-when-looped feature is disabled on
the port
Keep-alive The time interval between keepalive PDUs transmitted
toward the network during loop detection by the
down-when-looped feature
Loop Detected Indicates whether a loop is detected on the port
Retry The minimum wait time before the port is re-enabled after
it is brought down due to a loop detection
Use Broadcast Addr Indicates whether the down-when-looped feature has
been configured to compare the destination MAC
address of received PDUs to the broadcast MAC address
instead of the MAC address of the port
Table 67 Show Port Detail Output Fields (Ethernet, Access Mode)
Label Description
To Next Page
Loading...
