Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 665
Loopback The type of loopback configured on the port, either line,
internal, or none
Swap Mac Addr. Indicates whether MAC address swapping is enabled
Loopback Time Left The number of seconds left in a timed loopback
If there is no loopback configured or the configured
loopback is latched, the value is unspecified.
If configured loopback is persistent, the value persistent
Cfm Loopback Indicates whether the CFM loopback is enabled
Sync. Status Msg. Indicates whether Synchronization Status Messaging is
enabled on the port
Rx Quality Level The Synchronization Status Messaging quality level
value received on the port
Code-Type The Synchronization Status Messaging quality level code
type, either SONET or SDH
Tx Quality Level The Synchronization Status Messaging quality level
value transmitted on the port
Tx DUS/DNU Indicates whether the transmission of the QL-DUS/DNU
value in synchronization status messages is enabled or
disabled on the port
Configured Address The base chassis Ethernet MAC address
Hardware Address The interface hardware- or system-assigned MAC
address at its protocol sublayer
Cfg Alarm The type of alarms to be logged and reported for the port
Alarm Status The current alarm state
Table 67 Show Port Detail Output Fields (Ethernet, Access Mode)
Label Description
To Next Page
Loading...
