Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 705
Oper Duplex The operating duplex mode of the interface
Oper State up: the port is operationally up
down: the port is operationally down
Config Duplex full: the link is configured to full-duplex mode
half: the link is configured to half-duplex mode
Physical Link Yes: a physical link is present
No: a physical link is not present
MTU The size of the largest packet that can be sent/received
on the Ethernet physical interface, specified in octets
Single Fiber Mode Yes: single fiber mode
No: not single fiber mode
IfIndex The interface’s index number, which reflects its
initialization sequence
Hold time up The link-up dampening time in seconds
The port link dampening timer value that reduces the
number of link transitions reported to upper layer
protocols
Last State Change The last time that the operational status of the port
changed state
Hold time down The link-down dampening time in seconds. The down
timer controls the dampening timer for link down
transitions.
Configured Mode network: the port is configured for transport network use
access: the port is configured for service access
Encap Type null: ingress frames will not use any tags or labels to
delineate a service
dot1q: ingress frames carry 802.1Q tags, where each tag
signifies a different service
null&dot1q: applies only to port 1 and port 2 on the 2-port
10GigE (Ethernet) Adapter card and 2-port 10GigE
(Ethernet) module. The encapsulation type for these
ports is not user-configurable.
Table 72 Show Port Detail Output Fields (v-port) (Continued)
Label Description
To Next Page
Loading...
