Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 803
Output Example
*A:ALU-1># show lag 2 statistics
===============================================================================
LAG Statistics
===============================================================================
Description : LAG2
Port-id Input Input Output Output Input Output
Bytes Packets Bytes Packets Errors Errors
-------------------------------------------------------------------------------
1/4/3 0 9968 0 9833 0 0
1/5/3 0 435 0 401 0 0
-------------------------------------------------------------------------------
Totals 0 10403 0 10234 0 0
===============================================================================
*A:ALU-1>#
MC Lacp ID in use Indicates whether MC-LAG values such as system-id,
system priority, and lacp-key are advertised to the LACP
peer
MC extended timeout Indicates whether the system is using a larger value than
the value configured as the MC-LAG hold-on-neighbor-
failure value
MC Selection Logic The current state of the MC-LAG protocol, indicating
which of the two MC-LAG redundancy systems is the
master
MC Config Mismatch Indicates whether there is a LAG configuration mismatch
between redundancy systems, and what is mismatched
Port-id The member physical port ID expressed in slot/mda/port
format
Adm Up: the member port is administratively up
Down: the member port is administratively down
Act/Stdby Active: the member port is active
Standby: the member port is on standby
Opr Up: the member port is operationally up
Down: the member port is operationally down
Primary Indicates whether the member port is the primary port
Sub-group The member port subgroup
Prio The member port priority
Table 102 Show LAG Detailed Output Fields (Continued)
Label Description
To Next Page
Loading...
