7705 SAR Interfaces
834
Interface Configuration Guide
3HE 11011 AAAC TQZZA Edition: 01
Recovery Timeout The configured time after which the branch will
automatically be put back in the normal state (applies
only to MDDB and PCM)
Applicable only if recovery mode is auto; if recovery mode
is manual, the field displays N/A
Squelch Status The bitmap (32 bits) of the branches that are squelched
(applies only to MDDB and PCM). A value of 0x0 means
that no branch is squelched.
Force-active The master branch (1 or 2) to which the force-active
command has been applied (applies only to MDDB and
PCM)
Redundant Mode The redundancy mode for the master inputs: manual or
auto (applies only to MDDB and PCM)
Report Alarms The configured type of alarms to be reported to the bridge
(applies only to MDDB)
Speed The configured speed of the bridge (applies only to
MDDB)
Bridge Members
Identifier The branch ID in the format bridge-id.branch-id, where
bridge-id is 1 to 16 and branch-id is 1 to 32
Multidrop The type of device connected to the bridge, either master
or slave (applies only to MDDB and PCM)
AdminState The administrative state of the branch, either up or down
OperState The operational state of the branch, either up or down
AlarmStatus The current alarm state of the branch
Squelched Indicates whether the squelch function has been enabled
Scada Bridge Statistics
Packets Input/Output The total number of packets that were delivered by this
sublayer to a higher (sub) layer and that were not
addressed to a multicast or broadcast address at this
sublayer
The total number of packets that higher-level protocols
requested to be transmitted and that were not addressed
to a multicast or broadcast address at this sublayer,
including those that were discarded or not sent
Table 119 Show Specific SCADA Bridge Detail Output Fields (Continued)
Label Description
To Next Page
Loading...
