EasyManua.ls Logo

Nokia 7705 SAR - Page 833

Nokia 7705 SAR
902 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 833
Output Example
A:ALU-1># show scada 1/8/14 detail
===============================================================================
Scada Info
===============================================================================
Description : SCADA bridge 14
Bridge Id : 1/8/14 Type : Mddb
Admin Status : down Oper Status : down
Squelch : enabled Squelch Timeout : 120(s)
Squelch Recovery : manual Recovery Timeout : N/A
Squelch Status : 0x0 Force-active : 1
Redundant Mode : manual
Report Alarms : hcmOof hcmRai Speed : 2400
===============================================================================
Bridge Members
-------------------------------------------------------------------------------
Identifier Multidrop AdminState OperState AlarmStatus Squelched
-------------------------------------------------------------------------------
1/8/14.14 slave up down N
===============================================================================
Scada Bridge Statistics
===============================================================================
Input Output
-------------------------------------------------------------------------------
Packets 0 0
Discards 0 0
Unknown Proto Discards 0
===============================================================================
Table 119 Show Specific SCADA Bridge Detail Output Fields
Label Description
Scada Info
Description The description configured for the bridge
Bridge Id The bridge ID in the format slot/mda/bridge-id, where
bridge-id is 1 to 16
Type The bridge type: Mddb, pcm, or vcb
Admin Status The administrative state of the bridge, either up or down
Oper Status The operational state of the bridge, either up or down
Squelch Indicates whether the squelch function has been enabled
(applies only to MDDB and PCM)
Squelch Timeout The configured squelch timeout (applies only to MDDB
and PCM)
Squelch Recovery The squelch recovery mode: manual or auto (applies only
to MDDB and PCM)

Table of Contents

Related product manuals