Interface Configuration Guide 7705 SAR Interfaces
Edition: 01 3HE 11011 AAAC TQZZA 843
3.14.2.2.3 SCADA Monitor Commands
scada
Syntax scada scada-id [scada-id...(up to 5 total)] [interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command enables traffic monitoring for a SCADA bridge or branch. The statistical
information for the specified bridge or branch is shown at the configured interval until the
configured count is reached.
The first screen displays the current statistics related to the specified bridge or branch. The
subsequent statistical information listed for each interval is displayed as a delta to the
previous screen.
When the keyword rate is specified, the “rate per second” for each statistic is displayed
instead of the delta.
Monitor commands are similar to show commands, but only statistical information is shown.
Monitor commands display the selected statistics according to the configured number of
times at the interval specified.
Parameters scada-id — specifies a bridge-id or a branch-id. For a bridge-id, the format is slot/mda/
bridge-id, where bridge-id is 1 to 16. For a branch-id, the format is slot/mda/bridge-
id.branch-id, where bridge-id is 1 to 16 and branch-id is 1 to 32. Up to five scada-ids
can be specified.
seconds — configures the interval for each display in seconds
Values 3 to 60
Default 10
repeat — configures how many times the command is repeated
Values 1 to 999
Default 10
absolute — when the absolute keyword is specified, the raw statistics are displayed
without processing. No calculations are performed on the delta or rate statistics.
rate — when the rate keyword is specified, the rate per second for each statistic is
displayed instead of the delta; the default mode is delta
To Next Page
Loading...
