Node Configuration
The “Node Configuration” window can be used to control different parameters within the manifold. These parameters include,
“IP Address”, “Subnet Mask”, “Gateway Address”, “SMTP Server”, “DHCP/BOOTP enabled”, “MAC Address”, and “COMM
Fault/Idle Mode”. “DHCP/BOOTP enabled” is controlled by a single check mark box. “COMM Fault/Idle Mode” has two options
that can be chosen: “Hold last Output State” and “Turn OFF All Outputs”. IP address, Subnet Mask, and DHCP/BOOTP enabled
selections can all be configured from this page.
To Next Page
Loading...
