Olympus RollerFORM - Figure 6-26 Accessing the Captive Screws of the Flange with the Liquid-Control Valves from Inside the Liquid Chamber

DMTA-20073-01EN, Rev. C, November 2015
Chapter 6 100
Figure 6-26 Accessing the captive screws of the flange with the liquid-control
valves from inside the liquid chamber
4. Remove the flange that contains the liquid-control valves.
5. Remove the stainless steel rings from inside the tire. Do the following:
a) Push the tire lip inward to move the ring out of its retaining groove (see
Figure 6-27 on page 101).
Two of the four captive
screws accessed from
inside the liquid
chamber