DMTA-20073-01EN, Rev. C, November 2015
Maintenance
83
Figure 6-11 Pushing the C-clip in the groove on the probe-axle end with the C-clip
installation tool
Make sure that the retaining C-clip is properly seated in the groove on the axle-
end (see Figure 6-12 on page 84). When the C-clip is deformed or does not stay
well seated, replace it with a new one.
Push down on C-clip
installation tool over
C-clip
Probe-cable side end of
probe-axle resting on a
hard and flat surface
To Next Page
Loading...
