Olympus RollerFORM - Default Chapter; Figure I-1 Labels on the Rollerform; Labels and Symbols

DMTA-20073-01EN, Rev. C, November 2015
Labels and Symbols 1
Labels and Symbols
Safety-related labels and symbols are attached to the RollerFORM scanner at the
locations shown in Figure i-1 on page 1 and Figure i-2 on page 2. If any labels or
symbols are missing or illegible, please contact Olympus. The descriptions of the
symbols are provided in Table 1 on page 2.
Figure i-1 Labels on the RollerFORM
Labels on the underside of
the RollerFORM frame
Label on the Mini-Wheel
encoder. The encoder is
mounted on the underside
of the RollerFORM frame.