Olympus RollerFORM - 2. Setting Up the Instrument; 2.1 Connecting the RollerFORM Scanner to the Instrument

DMTA-20073-01EN, Rev. C, November 2015
Setting Up the Instrument 29
2. Setting Up the Instrument
Before performing inspections, you must connect the RollerFORM scanner to a
compatible instrument, and then properly configure the instrument to scan using the
RollerFORM.
2.1 Connecting the RollerFORM Scanner to the Instrument
The RollerFORM can be connected to OmniScan PA series or TomoScan FOCUS series
instruments.
To connect the RollerFORM to the instrument
1. Connect the LEMO encoder connector to the instrument (see Figure 2-1 on
page 30).