DMTA-20073-01EN, Rev. C, November 2015
Maintenance
71
6. Maintenance
The RollerFORM scanner is designed to require minimal maintenance and servicing.
The following maintenance tasks can be performed:
• Periodic cleaning of contaminants from the acoustic wheel’s liquid chamber
• Removing air bubbles from the acoustic wheel before performing inspections
• Filling the acoustic wheel or adding liquid as needed
• Restoring the tire’s transparency
• Changing the acoustic wheel tire when it shows signs of wear
• Changing the Mini-Wheel encoder
• Changing the Mini-Wheel encoder’s position on the RollerFORM
• Changing the laser batteries
• Adjusting the angle of the laser beam guide
6.1 Removing the Acoustic Wheel from the RollerFORM Scanner
The RollerFORM’s acoustic wheel must be removed prior to cleaning the liquid
chamber, replacing the tire, or replacing the phased array probe.
To Next Page
Loading...
Need help?
General
