Olympus RollerFORM - List of Figures

DMTA-20073-01EN, Rev. C, November 2015
List of Figures 149
List of Figures
Figure i-1 Labels on the RollerFORM ................................................................................. 1
Figure i-2 Label and symbols on the Mini-Wheel encoder .............................................. 2
Figure i-3 The RollerFORM scanner ................................................................................. 15
Figure 1-1 The contents of the RollerFORM case ............................................................. 17
Figure 1-2 The RollerFORM components ......................................................................... 19
Figure 1-3 Acoustic wheel components ............................................................................ 20
Figure 1-4 Underside of RollerFORM, showing the three wheels and encoder ......... 22
Figure 1-5 The 1.0 L manual pump and feeding tube ..................................................... 24
Figure 1-6 The feeding tube valve in the closed position ............................................... 25
Figure 1-7 The manual pump piston and trigger mechanism ....................................... 26
Figure 2-1 An OmniScan instrument with RollerFORM cables connected ................. 30
Figure 2-2 Unidirectional scan ............................................................................................ 32
Figure 2-3 Bidirectional scan ............................................................................................... 33
Figure 2-4 The Indexer Clicker on the top left-hand side of the RollerFORM handle 34
Figure 2-5 Index value in OmniScan ................................................................................. 36
Figure 2-6 The Start Acquisition button on the top right-hand side of the RollerFORM
handle .................................................................................................................. 37
Figure 3-1 The open OUT valve on the flange ................................................................. 42
Figure 3-2 Connecting the feeding tube adaptor to the IN check valve ....................... 43
Figure 3-3 The feeding tube valve in the open position ................................................. 44
Figure 3-4 The manual pump piston ................................................................................. 45
Figure 3-5 Measuring the gap between the acoustic wheel flange and the surface ... 47
Figure 4-1 Adjusting the probe angle to optimize the signal ......................................... 51
Figure 4-2 Unlocking the middle wheel ............................................................................ 53
Figure 4-3 Locking the middle wheel ................................................................................ 54
Figure 4-4 Unlocking the middle wheel ............................................................................ 55
Figure 4-5 Unlocking the middle wheel ............................................................................ 56
Figure 4-6 Keeping both rollers in contact with a convex surface ................................ 57
Figure 4-7 Keeping both rollers or the skid plate in contact with a narrow surface .. 58
Figure 4-8 Locking the middle wheel ................................................................................ 59