Omron C200H-MC221 - Page 249

Appendix AControl Bit/Flag Timing Charts
229
13. Automatic/Manual Mode Bit, Cycle Start Bit, and Pause Bit
Cycle Start Bit
Operation
Pause Bit
Automatic/Manual
Mode Bit
Program execution is stopped when the Automatic/Manual Mode Bit is turned OFF. The Unit is in manual mode, so
the Pause Bit is ignored.
14. Automatic/Manual Mode Bit, Cycle Start Bit, and Pause Bit
Cycle Start Bit
Operation
Pause Bit
Automatic/Manual Mode Bit
After program execution is paused with the Pause Bit, the Unit is switched to manual mode by turning OFF the
Automatic/Manual Mode Bit.
15. Automatic/Manual Mode Bit, Cycle Start Bit, and Forced Block End Bit
Cycle Start Bit
Operation
Forced Block End Bit
Automatic/Manual Mode Bit
Program execution is stopped by turning OFF the Automatic/Manual Mode Bit. The Forced Block End Bit is
ignored.