Outputting/Controlling with Ethernet
124
FQ-CR2 User’s Manual
The following range of values can be output.
−2,147,483.648 ≤ Measured value ≤ 2,147,483.647
If the measured value is lower than −2,147,483.648, then −2,147,483.648 is output.
If the measured value is higher than 2,147,483.648, then 2,147,483.648 is output.
The following values are output if JG (Judge) is set.
OK: 0 (0 × 1000)
NG: −1000 (−1 × 1000)
Binary output does not use data separators, i.e., field separators or record separators. These separators are used
only for ASCII output.
Data that is output after measurement is output until the last data even after the measurement is finished. Data out-
put is not interrupted midway.
Note
Note
FQ Sensor User Manual.book 124 ページ ２０１１年７月８日 金曜日 午後２時３０分
To Next Page
Loading...
Need help?
General
