Omron FQ-CR2 - Page 63

Starting Operation
FQ-CR2 User’s Manual
61
6
Operation
• Returning to Setup Mode
Press and press [Sensor settings].
• Signal Status When Moving to Run Mode
When moving to Run Mode, the signal will change as shown below and data can be input from and output to an
external device.
Note
ON
OFF
The BUSY signal that was
always ON will turn OFF.
BUSY signal
Display
Run Mode
Setup Mode
FQ Sensor User Manual.book 61 ページ ２０１１年７月８日 金曜日 午後２時３０分