User Manual
Advanced Console Server & RIM Gateway User Manual 113
5.8.2 Configuring client devices
Client devices on the local network must be configured with Gateway and DNS settings. This can be done statically on
each device, or using DHCP (on IM and ACM models).
Manual Configuration:
Manually set a static gateway address (being the address of the console server) and set the DNS server address to be
the same as used on the external network i.e. if the console server is acting as an internet gateway or a cellular router,
then use the ISP provided DNS server address.
DHCP Configuration (IM/ACM families only):
 Navigate to the System:IP page
 Click the tab of the interface connected to the internal network. To use DHCP, a static address must be set; check
that the static IP and subnet mask fields are set.
To Next Page
Loading...
Need help?
General
