User Manual
Advanced Console Server & RIM Gateway User Manual 67
Next you must select whether to generate keys using RSA and/or DSA (if unsure, select only RSA). Generating each set
of keys will require approximately two minutes and the new keys will destroy any old keys of that type that may previously
been uploaded. Also while the new generation is underway on the master functions relying on SSH keys (e.g. cascading)
may stop functioning until they are updated with the new set of keys. To generate keys:
 Select RSA Keys and/or DSA Keys
 Click Apply
 Once the new keys have been successfully generated simply Click here to return and the keys will automatically
be uploaded to the Master and connected Slaves
4.6.2 Manually generate and upload SSH keys
Alternately if you have a RSA or DSA key pair you can manually upload them to the Master and Slave console servers.
Note If you do not already have RSA or DSA key pair and you do not wish to use you will need to create a key pair
using ssh-keygen, PuTTYgen or a similar tool as detailed in Chapter 15.6
To manually upload the key public and private key pair to the Master console server:
 Select System: Administration on Master’s Management Console
 Browse to the location you have stored RSA (or DSA) Public Key and upload it to SSH RSA (DSA) Public Key
 Browse to the stored RSA (or DSA) Private Key and upload it to SSH RSA (DSA) Private Key
 Click Apply
To Next Page
Loading...
Need help?
General
