Chapter 4: Serial Port, Device and User Configuration
64 Console Server & RIM Gateway User Manual
 Add or edit the Permitted Services (or TCP/UDP port numbers) that are authorized to be used in controlling this
host. Only these permitted services will be forwarded through by SDT to the Host. All other services (TCP/UDP
ports) will be blocked.
 The Logging Level specifies the level of information to be logged and monitored for each Host access (refer
Chapter 7 - Alerts and Logging)
 If the Host is a PDU or UPS power device or a server with IPMI power control, then specify RPC (for IPMI and
PDU) or UPS and the Device Type. The Administrator can then configure these devices and enable which users
have permissions to remotely cycle power etc (refer Chapter 8). Otherwise leave the Device Type set to None
 If the console server has been configured with distributed Nagios monitoring enabled then you will also be
presented with Nagios Settings options to enable nominated services on the Host to be monitored (refer
Chapter 10 – Nagios Integration)
 Click Apply. This will create the new Host and also create a new Managed Device (with the same name)
4.5 Trusted Networks
The Trusted Networks facility gives you an option to nominate specific IP addresses that users (Administrators and
Users) must be located at, to have access to console server serial ports:
 Select Serial & Network: Trusted Networks
 To add a new trusted network, select Add Rule
To Next Page
Loading...
Need help?
General
