User Manual
Advanced Console Server & RIM Gateway User Manual 187
 You may optionally calibrate the EMD with a Temperature Offset (+ or - °C) or Humidity Offset (+ or percent).
Also if you check Temperature in Fahrenheit then the temperature will be reported in Fahrenheit. Otherwise it
will be reported in degrees Celsius
 Provide Labels for each of the alarm sensors you will used e.g. Door Open or Smoke Alarm.
 Check Log Status and specify the Log Rate (minutes between samples) if you wish the status from this EMD to
be logged. These logs can be views from the Status: Environmental Status screen
 Click Apply. This will also create a new Managed Device (with the same name)
 For the ACM5000-E select the Serial & Network: Environmental menu and check Enabled. You will then need
set any temperature offsets and label the sensors as described above