Table of Contents
8 Console Server & RIM Gateway User Manual
10.3.2 Enable NRPE monitoring 214
10.3.3 Enable NSCA monitoring 214
10.3.4 Configure selected Serial Ports for Nagios monitoring 215
10.3.5 Configure selected Network Hosts for Nagios monitoring 216
10.3.6 Configure the upstream Nagios monitoring host 217
10.4 Advanced Distributed Monitoring Configuration 217
10.4.1 Sample Nagios configuration 217
10.4.2 Basic Nagios plug-ins 220
10.4.3 Additional plug-ins 220
10.4.4 Number of supported devices 222
10.4.5 Distributed Monitoring Usage Scenarios 223
SYSTEM MANAGEMENT 226
11.1 System Administration and Reset 226
11.2 Upgrade Firmware 227
11.3 Configure Date and Time 228
11.4 Configuration Backup 229
11.5 Delayed Configuration Commit 231
11.6 FIPS Mode 232
STATUS REPORTS 234
12.1 Port Access and Active Users 234
12.2 Statistics 234
12.3 Support Reports 235
12.4 Syslog 236
12.5 Dashboard 236
12.5.1 Configuring the Dashboard 237
12.5.2 Creating custom widgets for the Dashboard 238
MANAGEMENT 240
13.1 Device Management 240
13.2 Port and Host Logs 240
13.3 Terminal Connection 240
13.3.1 Web Terminal 241
13.3.2 SDT Connector access 242
13.4 Power Management 243
CONFIGURATION FROM THE COMMAND LINE 244
14.1 Accessing config from the command line 244
14.1.1 Serial Port configuration 246
14.1.2 Adding and removing Users 249
14.1.3 Adding and removing user Groups 250
14.1.4 Authentication 251
14.1.5 Network Hosts 251
14.1.6 Trusted Networks 253
14.1.7 Cascaded Ports 253
14.1.8 UPS Connections 254
14.1.9 RPC Connections 255
14.1.10 Environmental 256
14.1.11 Managed Devices 256
14.11.12 Port Log 257
14.1.13 Alerts 257
14.1.14 SMTP & SMS 260
14.1.15 SNMP 260
14.1.16 Administration 261
14.1.17 IP settings 261
14.1.18 Date & Time settings 262
14.1.19 Dial-in settings 262
14.1.20 DHCP server 263
14.1.21 Services 264
To Next Page
Loading...
Need help?
General
