D-4 Workstation 5A Setup Guide - Fourth Edition
Oracle Linux for MICROS
General Information
Using the Recovery Button to Perform a System Recovery in
Oracle Linux for MICROS
1. Turn off the workstation.
2. Remove the workstation from stand and unplug all cables except
power and a keyboard.
3. Locate the recovery button on back of the workstation.
4. Use a hex wrench or paper clip to hold down the recovery button on
the bottom of the workstation.
5. While holding down the recovery button, press and hold the power
button for 1 second, and then release both buttons to begin the system
recovery process.
• Ignore any Invalid BIOS messages that appear.
• When prompted with Y/N?, press Y, and then press Enter.
• Recovery continues for approximately six minutes.
Attention!
System Recovery
The Oracle MIROS Workstation 5A with Oracle Linux
f
or MICROS supports system recovery only via the
recovery button. BIOS-based system recovery available
at a later date.
To Previous Page
Loading...
Need help?
General
