4-38 Workstation 5A Setup Guide - Fourth Edition
Installing and Operating the Workstation 5A
Workstation 5A Recovery
• You can enter the path, filename, and extension directly from the error box,
or modify the RECOV.DAT file with the correct path and Ghost image
filename. The full path is required only if the image file is not located on
the root of the CF Card.
Error: ‘Recovery Detected 2 USB Hard Drives Installed on the
System’
The POSReady Recovery CF generates this error message if:
• 1) A USB Thumb or Flash Drive remains attached to the IO panel and a
USB Hard Drive is attached to J8.
• 2) The WS5A contains both an optional SATA disk drive and USB Hard
Drive attached to J8.
In the first case, be sure to remove all USB Drives from the IO Panel. The
POSReady 2009 Recovery CF cannot determine if a USB Flash Drive
connected to the IO Panel or the USB Hard Drive connected to J8 is the boot
device.
In the second case, when both an optional SATA disk drive and USB Hard Disk
are installed, the Recovery CF cannot determine which is the boot device. One
device should be removed.
To Next Page
Loading...
Need help?
General
