Panasonic FP0 User Manual

Table of Contents
FP0
ix
8.5.2 Operation and Precautions at Run Start Time 8 − 14...............
8.5.3 Precautions When Using a Control Instruction 8 − 16...............
8.6 Precautions for Programming 8 − 18.....................................
8.7 Rewrite Function During RUN 8 − 19.....................................
8.7.1 Operation of Rewrite During RUN 8 − 19..........................
8.7.2 Cases Where Rewriting During Run is not Possible 8 − 20..........
8.7.3 Procedures and Operation of Rewrite During RUN 8 − 22...........
8.7.4 Changing Modes in FP Programmer II 8 − 23......................
8.8 Changing the Set Value of Timer/Counter During RUN 8 − 24...............
8.8.1 Method of Rewriting Constant in FP Programmer II 8 − 24..........
8.8.2 Method of Rewriting a Value in the Set Value Area 8 − 25...........
8.9 Processing During Forced Input and Output 8 − 28........................
8.10 Setting the Clock/Calendar Timer (T32CT type only) 8 − 29.................
Chapter 9 High−speed Counter/Pulse Output/ PWM Output
9.1 Outline of Functions 9 − 3...............................................
9.1.1 Three Functions that Use Built−in High−speed Counter 9 − 3.........
9.1.2 Performance of Built−in High−speed Counter 9 − 4..................
9.2 Specifications and Restricted Items 9 − 5..................................
9.2.1 Specifications 9 − 5.............................................
9.2.2 Functions and Restrictions 9 − 7..................................
9.3 High−speed Counter Function 9 − 9......................................
9.3.1 Outline of High−speed Counter Function 9 − 9......................
9.3.2 Types of Input Modes 9 − 9......................................
9.3.3 I/O Allocation 9 − 11............................................
9.3.4 Instructions Used with High−speed Counter Function 9 − 12.........
9.3.5 Sample Program 9 − 14........................................
9.4 Pulse Output Function 9 − 18...........................................
9.4.1 Outline of Pulse Output Function 9 − 18..........................
9.4.2 Control Mode 9 − 19...........................................
9.4.3 I/O Allocation and Wiring 9 − 20.................................
9.4.4 Instructions Used with Pulse Output Function 9 − 22...............
9.4.5 Sample Program for Positioning Control 9 − 25....................
9.5 PWM Output Function 9 − 33...........................................
9.5.1 Outline of PWM Output Function 9 − 33..........................
9.5.2 Instruction Used with PWM Output Function 9 − 33.................
Chapter 10 General−use Serial Communications
10.1 General−use Serial Communications Function 10 − 3......................

Panasonic FP0 Specifications

General

Model	FP0
Communication Ports	RS232C, RS485
Power Supply	24V DC
Operating Temperature	0°C to 55°C
Type	Programmable Logic Controller (PLC)
I/O Points	16 to 128