14-34
Name Boolean Symbol Description
Steps
Note1)
Basic function instructions
TML
After set value “n” x 0.001 seconds, timer contact “a” is set
to on.
3 (4)
TMR
After set value “n” x 0.01 seconds, timer contact “a” is set
to on.
3 (4)
TMX
After set value “n” x 0.1 seconds, timer contact “a” is set to
on.
3 (4)
On-delay
timer
TMY
After set value “n” x 1 second, timer contact “a” is set to on. 4 (5)
Auxiliary
timer (16-bit)
F137
(STMR)
After set value “S” x 0.01 seconds, the specified output and
R900D are set to on.
5
Auxiliary
timer (32-bit)
F183
(DSTM)
After set value “S” x 0.01 seconds, the specified output and
R900D are set to on.
7
Time
constant
processing
F182 Executes the filter processing for the specified input. 9
Counter
CT Decrements from the preset value “n” 3 (4)
UP/DOWN
counter
F118
(UDC)
Increments or decrements from the preset value “S” based
on up/donw input.
5
Note1) In the FP2/FP2SH/FP10SH, when timer 256 or higher, or counter 255 or lower, is used, the
number of steps is the number in parentheses. Also, in the FP2/FP2SH/FP10SH, when a timer
number or counter number has an index modifier, the number of steps is the number in
parentheses.
To Next Page
Loading...
