Panasonic FP0

14-88
Num-
ber
Name Boolean Operand Description Steps
F142
P142
Watching
dog timer
update
WDT
PWDT
S The time (allowable scan time for the system) of
watching dog timer is changed to “S” × 0.1 (ms) for
that scan.
3
F143
P143
Partial I/O
update
IORF
PIORF
D1, D2 Updates the I/O from the number specified by “D1”
to the number specified by “D2”.
5
F144
Serial data
communica-
tion control
TRNS S, n The COM port received flag (R9038) is set to off to
enable reception.
Beginning at “S”, “n” bytes of the data registers are
sent from the COM port.
5
F145
P145
Data send SEND
PSEND
S1, S2, D, N Sends the data to another station in the network
(MEWNET).
9
F146
P146
Data receive RECV
PRECV
S1, S2, N, D Receives the data to another station in the network
(MEWNET).
9
F145
P145
Data send SEND S1, S2, D, N Sends the data to the slave station as the MOD
bus master.
9
F146
P146
Data receive RECV S1, S2, N, D Receives the data from the slave station as the
MOD bus master.
9
F145
P145
Data send SEND S1, S2, D, N Sends the data to the slave station as the
MEWTOCOL master.
9
F146
P146
Data receive RECV S1, S2, N, D Receives the data from the slave station as the
MEWTOCOL master.
9
F147 Printout PR S, D Converts the ASCII code data in the area starting
with “S” for printing, and outputs it to the word
external output relay WY specified by “D”.
5
F148
P148
Self-
diagnostic
error set
ERR
PERR
n
(n: k100 to
K299)
Stores the self-diagnostic error number “n” in
(DT9000 for FP0/FP-e/FP1/FP-M/FP3 or DT90000
for FP0 T32/FPΣ/FP2/FP2SH/FP10SH), turns
R9000 on, and turns on the ERROR LED.
3