7.1.2 Flash/Recall/Terminate
Description
A
proprietary telephone (PT) user can use the FLASH/RECALL button (Flash/Recall mode or Terminate mode)
or Terminate button (Terminate mode) to disconnect the current call and originate another call without hanging
up.
Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the line used last.
For example, if a CO line call is disconnected, the extension user will hear a new dial tone from the same CO
line.
Terminate Mode: Disconnects the line and the extension user hears a dial tone via the preferred CO line.
(® 12.1.3 Line Preference—Outgoing)
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
– Flash/Recall mode
– Terminate mode
– EFA mode (® 6.1.1 EFA (External Feature Access))
• Terminate Button
Any flexible button can be customized as the Terminate button.
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same CO line is programmable for each CO line
port.
• This feature generates a Station Message Detail Recording (SMDR) call record (® 18.1.6 SMDR (Station
Message Detail Recording)), restarts the call timer, inserts a pause, and checks the Toll Restriction (TRS)
level (® 19.1.5 TRS (Toll Restriction)) again.
• The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of the mode
that the FLASH/RECALL button has been set to, in the following situations:
– When a call is made using ARS. (® 2.1.3 ARS (Automatic Route Selection))
– When a CO line call is made with the INTERCOM button.
– When a CO line call is made with an Incoming Call Distribution (ICD) group button.
• For general SIP phones, the function of a FLASH button differs depending on the phone, and its
functionality does not depend on the setting specified in the PBX.
PC Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port—
Disconnect Time
12.1.1 PBX Configuration—[4-1-1] Extension
—Wired Extension—Extension Settings—Option 7—
Flash
Mode during CO Conversation
12.1.4 PBX Configuration—[4-1-4] Extension
—Wired Extension—Flexible Button—
Type
12.2.1 PBX Configuration—[4-2-1] Extension
—Portable Station—Extension Settings—Option 7—
Flash
Mode during CO Conversation
12.2.3 PBX Configuration—[4-2-3] Extension
—Portable Station—Flexible Button—
Type
Feature Manual References
7.1.3 Flexible Buttons
140 Feature Manual Document Version 2016-03
7.1.2 Flash/Recall/Terminate
To Next Page
Loading...
