PC Programming Manual References
10.8.1 PBX Configuration
—[2-8-1] System—Ring Tone Patterns—Call from CO—
Ring Tone Pattern Plan
1–8
10.8.2 PBX Configuration—[2-8-2] System—Ring Tone Patterns
—Call from DOORPHONE—
Ring Tone
Pattern Plan 1–8
10.8.3
PBX Configuration—[2-8-3] System—Ring Tone Patterns—Call from Others—
Extension—Ring
Tone
Pattern Plan 1–8
10.9 PBX Configuration—[2-9] System—System Options—Option 1—
PT Operation—PT Ring Off Setting
12.1.1 PBX Configuration—[4-1-1] Extension
—Wired Extension—Extension Settings
→Option 1—
Ring Pattern Table
→Option 6— ICM Tone
12.1.4 PBX Configuration—[4-1-4] Extension
—Wired Extension—Flexible Button—
Optional Parameter
(Ringing Tone Type Number)
(for Loop CO, Single CO, Group CO, ICD Group, SDN)
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings—Option 1—
Ring
Pattern Table
Feature Manual References
23.1 Capacity of System Resources
Operating Manual References
3.1.4 Customizing the Buttons—To specify the ringing tones for each CO, ICD Group, PDN, SDN, or
INTERCOM button (DPT/IP-PT only)
17.1.3 Room Status Control
Description
A proprietary telephone
(PT) with a 6-line display designated as the hotel operator extension can be used to
view and set the Check-in/Check-out/Cleaned-up (Ready or Not Ready) status of guest rooms associated with
extensions.
Any wired extension can be used as a room extension without special programming.
Flexible buttons on the hotel operator’s extension can be set as Room Status Control buttons. The 3 types of
Room Status Control buttons are as follows:
• Check-in
Switches the status of selected room extensions from Check-out to Check-in.
Remote Extension Dial Lock is turned off, allowing calls to be made from the extension.
• Check-out
Switches the status of selected room extensions from Check-in to Check-out.
Room extension data, such as Timed Reminder or Last Number Redial data, is cleared, and Remote
Extension Dial Lock is turned on, restricting some calls. This can be useful to prevent the room extension
from being used when no guest is checked in.
• Cleaned-up
Switches the status of selected room extensions between Ready and Not Ready.
Document Version 2016-03 Feature Manual 337
17.1.3 Room Status Control
To Next Page
Loading...
