Panasonic KX-NS1000 - Intercept Routing

Destination Type Availability
UM Group
ü
VM Group (DTMF/DPT)
ü
Fax Unit
ü
External Pager (TAFAS)
ü
DISA
ü
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
Extension of Another PBX (via TIE Line, Access with PBX Code)
Extension of Another PBX (via TIE Line, Access without PBX Code)
ü
5. Intercept Routing
After a call has been directed to its DIL, DID, or CLI destination, the following Intercept Routing features,
if programmed, can redirect the call.
Type Description Details in
No Answer (IRNA) If a called party does not answer a call within a
preprogrammed time period
(Intercept time), the
call is redirected to a preprogrammed destination.
®
10.1.12 Intercept
Routing
Busy If a called party is already handling another call,
the new call is redirected to a preprogrammed
destination.
DND If a called party is in Do Not Disturb (DND)
mode,
the call is redirected to a preprogrammed
destination.
No Destination If a destination is not assigned, the call is
redirected to an operator.
®
10.1.13 Intercept
Routing—No
Destination
PC Programming Manual References
18.2 PBX Configuration
—[10-2] CO & Incoming Call—DIL Table & Port Settings—DIL—
Trunk Property
10.1.12 Intercept Routing
Description
Redirects an incoming CO line call or intercom call to a preprogrammed destination when the original
destination does not, or cannot, answer the call. There are four types of Intercept Routing, described below.
Document Version 2016-03 Feature Manual 201
10.1.12 Intercept Routing