Extension settings can be switched allowing multiple extension users to use the same telephone as
follows:
Service-in
Extn. 102
Extn. 101
Service-out
Extn. 101
Service-out
Extn. 101
Service-in
Virtual
Location
Extn. 102
Service-out
Virtual
Location
Extn. 102
Service-out
Virtual
Location
Service-in Service-inService-out
Service-out
Service-in
Explanation:
The extension user of extension 101 changes to service out mode. The extension user of extension 102
switches extension settings and changes his extension to Service
-in mode.
Conditions
• This feature is not available for PSs, T1 OPX extensions, and SIP extensions.
• An extension personal identification number (PIN) is required to use this feature. (® 6.1.10 Extension PIN
(Personal Identification Number))
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—
Walking Extension
Feature Manual References
22.1.2 Walking Extension
Operating Manual References
1.3.76 Walking Extension, Enhanced
22.1.4 Walking Extension-Home position control
Description
The Walking Extension and Enhanced Walking Extension features include the Home position control feature
which can be set through system programming.
The Enable/Disable setting for Home position control applies to both the Walking Extension and Enhanced
Walking Extension features.
Disable: Location Switch
The location of the extensions are switched.
Enable: Return to the home location
When
the location of the extensions are switched via Walking Extension or Enhanced Walking Extension, they
are returned to their original locations (home locations).
Document Version 2016-03 Feature Manual 453
22.1.4 Walking Extension-Home position control
To Next Page
Loading...
