a. When an SLT user answers a call, a reorder tone is heard or no one is heard on the other end.
b. When an SLT user goes off-hook, a reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems, choose
"Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number is entered
after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.
• Hold Alarm tone pattern has a default. (® 23.2 Tones/Ring Tones)
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone
→ Recall—Hold Recall
→ Recall—Disconnect after Recall
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan
—Main—Features
→
Call Hold / Call Hold Retrieve
→ Call Hold Retrieve : Specified with a Holding Extension Number
→ Hold Retrieve : Specified with a Held CO Line Number
10.9 PBX Configuration
—[2-9] System—System Options
→Option 1—
PT Operation—Automatic Hold by ICM / CO / ICD Group Key
→Option 1— PT Operation—Hold key mode
→Option 5— SLT—SLT Hold Mode
Operating Manual References
1.3.6 Call Hold
4.1.5 Call Log, Incoming
Description
When a call containing Caller ID information is received by an extension, the information is shown on the
telephone display, notifying the extension user of the caller
’s identity. This information is also automatically
logged in the Incoming Call Log of the extension, and can be viewed later or used to call that caller back.
Also, depending on system programming, incoming intercom calls (including over a TIE connection) are logged
in the incoming call log.
Each extension and incoming call distribution (ICD) group has its own Incoming Call Log.
Call Log Button
The Call Log button will alert an extension user to any missed (unanswered) calls. A flexible button can be
customized as the Call Log button, and will indicate the status of the Incoming Call Log for the extension or
corresponding ICD group, as shown below.
Light pattern Status of the corresponding call log
Red on There are call records in the log which have not been viewed.
Off There are no new call records in the log.
Document Version 2016-03 Feature Manual 55
4.1.5 Call Log, Incoming
To Next Page
Loading...
