Panasonic KX-NS1000 - IP-PT (IP Proprietary Telephone)

[Registration]
• IP-CSs that support LAN synchronization (KX-NS0154 only) are automatically assigned a LAN
Synchronization Group number, according to the site they are registered to. If the maximum number of
CSs have already been registered, no group number will be assigned.
[Synchronization]
• Slave IP-CSs can be added to a LAN synchronization group as desired. They will automatically synchronize
themselves with the other IP-CSs.
• To enable easy setup, LLDP is supported by IP-CSs (KX-NS0154 only). If this feature causes network
congestion, it can be disabled.
• Only KX-NS0154 IP-CSs support LAN synchronization.
• If the IP-CS is using LAN synchronization, it can continue operation without restarting, even if the system
data is changed during operation.
• Even in LAN synchronization, it is possible to also use air synchronization. However, this is only possible
between KX-NS0154 IP-CSs.
• You must specify a LAN synchronization group number or an air synchronization group number for each
IP-CS. Do not leave both of these settings unspecified.
• In air synchronization, if the CS loses its synchronization signal, it will continue to run independently. Any
current calls will remain connected. Unlike previous IP-CS models (e.g., KX-NCP0158), the Watching
Degeneracy timer does not apply to the KX-NS0154 IP-CS.
PC Programming Manual References
7.4.4 Utility—Monitor/Trace—CS Status Monitor—Air Sync Group
7.4.5 Utility—Monitor/Trace—CS Status Monitor—LAN Sync Group
7.5.5 Utility—Report—IP-CS Information
9.5.1 PBX Configuration—[1-1] Configuration—Slot—Site Property—Main
→Main—
LLDP Packet Sending Ability
→Main— IP-CS Registration Mode
→Port Number— Firmware Update Port No. for IP-PT/IP-CS (Media Relay)
9.5.1 PBX Configuration—[1-1] Configuration
—Slot—Site Property—Main—Media Relay
→
IP Extension / IP-CS—NAT - MGCP Server Port No. for IP-CS
→ IP Extension / IP-CS—Keep Alive Packet Type for IP-CS
→ IP Extension / IP-CS—NAT - FTP Server Port No.
9.18 PBX Configuration
—[1-1] Configuration—Slot—V-IPCS4—Card Property
9.19 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Port Property
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous—
Air
Synchronization
—Watching Degeneracy (x60s)
Feature Manual References
2.1.7 Automatic Rerouting to Secondary PBX
10.1.17 IP-PT (IP Proprietary Telephone)
Description
IP Proprietary Telephones (IP-PTs) are telephones that make and receive calls using IP and that connect to
the PBX over a LAN. Except for their use of IP, they function almost identically to traditional proprietary
telephones.
IP-PTs have two Ethernet ports for connection, primary and secondary. They are connected to the PBX through
a network hub or other splitting device, and can have a PC connected to the secondary Ethernet port.
Document Version 2016-03 Feature Manual 211
10.1.17 IP-PT (IP Proprietary Telephone)