PC Programming Manual References
9.25 PBX Configuration
—[1-1] Configuration—Slot—Port Property - LCO Port
→
Dialing Mode
→ DTMF Width
→ Pulse Speed
5.1.5 Dial Tone
Description
The following dial tones inform extension users about features activated on their extensions:
Each dial tone type has two frequencies, such as dial tone 1A and dial tone 1B.
Type Description
Tone 1A/1B A normal dial tone is heard when:
a. No features listed for dial tones 2 through 4 has been set, or
b. Automatic Route Selection
(ARS) is used.
Tone 2A/2B This tone is heard when:
• Any of the features below are set.
• Absent Message
• BGM
• Call Forwarding
(FWD)
• Call Pickup Deny
• Call Waiting
• Do Not Disturb (DND)
• Extension Dial Lock
• Executive Busy Override Deny
• Hot Line
• Timed Reminder
Tone 3A/3B This tone is heard when:
• A called PS is being searched for.
• Any of the features below are performed.
• Account Code Entry
• Consultation Hold
• Answering a Timed Reminder call with no message
Tone 4A/4B This tone is heard when new messages have been recorded for the
extension.
Conditions
• Dial Tone Type A/B
Through system programming, it is possible to select dial tone type A or B for dial tones 1 through 4. If
"Type A" is selected, all dial tones 1 through 4 will become dial tone type A.
The dial tone type for the ARS feature can be selected separately. If
"Type A" is selected for ARS, dial
tone 1A will be heard. If "Type B" is selected, dial tone 1B will be heard.
• Dial Tone Patterns
All dial tone patterns have a default (® 23.2 Tones/Ring Tones).
• Only dial tone 1 is sent to the extensions in a VM (DPT/DTMF) group.
92 Feature Manual Document Version 2016-03
5.1.5 Dial Tone
To Next Page
Loading...
