→Option 1— PT Fwd / DND—Paging to DND Extension
→Option 3— Confirmation Tone—Tone 2 : Paged / Automatic Answer
10.11.1 PBX Configuration
—[2-11-1] System—Audio Gain—Paging/MOH
→
Paging—EPG 1–6 (External Pager 1–6)
→ Paging—Paging Level from PT Speaker
11.4 PBX Configuration
—[3-4] Group—Paging Group
11.4.1 PBX Configuration—[3-4] Group—Paging Group—All Setting
11.4.2 PBX Configuration—[3-4] Group—Paging Group—External Pager
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
Feature Manual References
23.1 Capacity of System Resources
Operating Manual References
1.3.49 Paging
15.1.2 Pause Insertion
Description
Pressing a PAUSE button inserts a preprogrammed Pause time between digits of a user-dialed number before
the number is dialed out, allowing certain numbers separated with a pause to be used to access certain features
(e.g., access codes, seizing idle lines, etc.).
When a pause is needed, pauses must be inserted manually (pressing the PAUSE button) in all cases, except
for the following access codes where a pause is automatically inserted between the user-dialed access code
and the subsequent digits:
a. Host PBX Access code (® 9.1.5 Host PBX Access Code (Access Code to the Telephone Company from
a Host PBX))
b. Special Carrier Access code (® 18.1.8 Special Carrier Access Code)
c. Second Dial Tone Waiting code
Conditions
• The length of a pause is programmable for each CO line.
• Numbers stored in Memory Dialing can contain pauses.
• When a Second Dial Tone Waiting code is dialed after seizing a CO line, a preprogrammed number of
pauses are inserted after the code.
• ARS
A pause is not automatically inserted between the user-dialed access code and the subsequent digits when
the ARS mode is enabled. (® 2.1.3 ARS (Automatic Route Selection))
PC Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port—
Pause Time
10.3
PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous—
During Conversation—
Pause
Signal Time
14.4 PBX Configuration—[6-4] Feature—Second Dial Tone
256 Feature Manual Document Version 2016-03
15.1.2 Pause Insertion
To Next Page
Loading...
