Panasonic KX-NS1000 - Intercept Routing-No Destination

PC Programming Manual References
10.3 PBX Configuration
—[2-3] System—Timers & Counters
→Dial / IRNA / Recall / Tone—
Intercept Routing No Answer (IRNA)—Day, Lunch, Break, Night
→DISA / Door / Reminder / U. Conf— DISA—Intercept Timer—Day, Lunch, Break, Night
11.5.1 PBX Configuration—[3-5-1] Group
—Incoming Call Distribution Group—Group Settings
→Overflow No Answer—
Time out &
Manual Queue Redirection—Destination-Day, Lunch, Break, Night
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings
→Intercept Destination
→Intercept No Answer Time
12.2.1 PBX Configuration—[4-2-1] Extension—Portable Station—Extension Settings
→Intercept Destination
→Intercept No Answer Time
13.3.1 PBX Configuration—[5-3-1] Optional Device—Voice Message—DISA System—Option 1—
DISA
Intercept—Intercept when all DISA ports are busy
18.4 PBX Configuration
—[10-5] CO & Incoming Call—Miscellaneous
→
Intercept—Intercept Routing - DND (Destination sets DND.)
→ Intercept—Routing to Operator - No Destination (Destination is not programmed.)
→ Intercept—Intercept Routing for Extension Call
Feature Manual References
5.1.10 DISA (Direct Inward System Access)
5.1.13 DND (Do Not Disturb)
10.1.13 Intercept Routing—No Destination
Description
Directs a CO line call to an operator when the call has no assigned destination.
Conditions
• Intercept Routing—No Destination on/off
Intercept Routing—No Destination can be enabled or disabled for the entire system, through system
programming. If disabled, the caller will hear a reorder tone.
Note
that calls received through an ELCOT/LCOT or T1 (LCOT/GCOT) card will always be directed to an
operator, even when this feature is disabled.
• If an operator is not assigned:
The extension that is connected to the lowest numbered port and is ready to receive calls will be the
intercept destination.
• Intercept Routing—No Destination also applies to calls from doorphones.
PC Programming Manual References
10.2 PBX Configuration—[2-2] System—Operator & BGM—
PBX Operator—Day, Lunch, Break, Night
18.4 PBX Configuration
—[10-5] CO & Incoming Call—Miscellaneous—
Intercept—Routing to Operator -
No Destination (Destination is not programmed.)
Feature Manual References
14.1.9 Operator Features
206 Feature Manual Document Version 2016-03
10.1.13 Intercept Routing—No Destination