Panasonic KX-NS1000 - Call Park

Operating Manual References
1.3.7 Call Monitor
1.5.1 Cellular Phone Features
4.1.7 Call Park
Description
An
extension user can place a call into a common parking zone of the PBX. The Call Park feature can be used
as a transferring feature; this releases the user from the parked call to perform other operations. A parked call
can be retrieved by any extension user.
Conditions
• Automatic Call Park
It is possible to select an idle parking zone automatically.
• Retry
If the specified parking zone is occupied or there is no vacant zone for Automatic Call Park, the originator
will hear a busy tone. Retrying is possible while hearing a busy tone by selecting another parking zone or
a vacant zone.
• Call Park Recall
If a parked call is not retrieved within a preprogrammed time period, the Call Park Recall tone will be heard
at the Transfer Recall destination assigned to the extension which parked the call. If the destination is
engaged in a call, the Hold Alarm will be heard.
• If a parked CO line call is not retrieved within a preprogrammed time period (Default: 30 minutes), it is
automatically disconnected.
• Call Park Button
Pressing the Call Park button parks or retrieves a call in a preset parking zone.
Any flexible button can be customized as the Call Park button. It shows the current status of the preset
parking zone as follows:
Light pattern Status
Slow red flashing A call is parked in the preset parking zone
Off There are no parked calls
• Call Park (Automatic Park Zone) Button
Pressing the Call Park (Automatic Park Zone) button parks a call in an idle parking zone automatically.
Any flexible button can be customized as the Call Park
(Automatic Park Zone) button.
On a KX-UT series SIP phone, pressing a Call Park (Automatic Park Zone) button selects an idle parking
zone from among the Call Park (preset parking zone) buttons configured on the phone.
• Call Park Retrieve Deny
Internal Call Block (® 10.1.15 Internal Call Block) also determines which extensions’ calls an extension
user can retrieve from a parking zone, i.e., if extension 101 cannot call extension 201, then it cannot retrieve
extension 201’s parked calls either.
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone
→
Recall—Call Park Recall
→ Recall—Disconnect after Recall
60 Feature Manual Document Version 2016-03
4.1.7 Call Park