Conditions
[General]
• Not
all buttons are available for KX-UT-series SIP phones. For details about available flexible button types,
see 11.1.1 KX-UT Series SIP Phones.
[Self Labeling]
• Up to 12 characters can be assigned to the LCD of each flexible button through personal/system
programming.
® 12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button—
Label Name
• When an incoming CO line call is answered or a CO line is seized, the corresponding CO button will turn
Green and the LCD display will switch to the page that the corresponding CO button is registered in.
• It is not recommended to assign the System Alarm button when using this feature, because if an alarm
occurs when the System Alarm button is not on the visible page, the alarm will not be noticed.
PC Programming Manual References
10.3
PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous—
PT Display—PT
Last Display
Duration in Idle Mode
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
12.1.4.1 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button—Flexible button data copy
12.1.5 PBX Configuration—[4-1-5] Extension—Wired Extension—PF Button
12.2.3 PBX Configuration—[4-2-3] Extension—Portable Station—Flexible Button
Operating Manual References
1.3.62 Self Labeling (KX-NT366/KX-NT553/KX-NT556/KX-NT560/KX-UT248/KX-UT670 only)
3.1.4 Customizing the Buttons
7.1.4 Flexible Numbering/Fixed Numbering
Description
To dial another extension user or to access PBX features, the access numbers (extension numbers or feature
numbers) are required.
There are three types of numbering plans:
1. Flexible Numbering (available while a dial tone is heard)
2. Flexible Numbering (available while busy, DND, or ringback tone is heard)
3. Fixed Numbering (available while dialing or talking)
1. Flexible Numbering (available while a dial tone is heard)
Extension numbers and feature numbers which are available while a dial tone is heard can be customized
for easy use. The numbers must not conflict. It is also possible to use the default settings shown in the
following table.
a. Extension Numbers: Extension numbers consist of leading numbers and additional numbers.
Extension numbers (consisting of "0" through "9") can be assigned as follows:
• Numbering schemes: 1–64
• Leading number: up to three digits
• Additional number: up to two digits (default: two digits)
[Example]
If the number "3" is programmed as a leading number for the 1st extension numbering scheme, and
"XX" is programmed as the additional digits, extension numbers 300 through 399 are available.
144 Feature Manual Document Version 2016-03
7.1.4 Flexible Numbering/Fixed Numbering
To Next Page
Loading...
