Panasonic KX-NS1000 - 2.5.4.6 Trunk Busy Out

5.1.8 DIL (Direct In Line)
Description
Directs
an incoming public CO line call to a preprogrammed destination based on the CO line carrying the call.
Each CO line has a destination for each time mode.
[Method Flowchart]
A CO line call is received.
Yes
Yes
No
Does the call have
Caller ID information and is CLI
distribution enabled for the CO line in
the current time mode?
No
Has the caller
been stored in the System Speed
Dialing Table and has a CLI destination
been assigned?
The call is routed to the
DIL destination.
The call is routed to its
CLI destination.
The call is routed to an
operator (Intercept
Routing—No Destination).
Yes
Is a DIL destination assigned
for the current time mode?
No
[Programming Example: DIL Table]
The table can be programmed for each CO line.
Port No.
(CO Line No.)
01
02
Day
Enable
Enable
Lunch
Disable
Disable
Night
Disable
Disable
Break
Enable
Disable
Day
101
102
Lunch
100
100
Night
100
100
Break
101
102
CLI Distribution DIL Destination
*1
*1
® 18.2
PBX Configuration—[10-2] CO & Incoming Call—DIL Table & Port Settings—DIL—
DIL Destination—Day, Lunch,
Break, Night
In this example:
If a CO line call is received on CO line 01:
In
day mode: Calling Line Identification (CLI) distribution is enabled. The call is routed to its CLI destination, if
assigned. If not assigned, the call is routed to the Direct In Line (DIL) destination, extension 101.
In lunch mode: CLI distribution is disabled. The call is routed to the DIL destination, extension 100.
96 Feature Manual Document Version 2016-03
5.1.8 DIL (Direct In Line)