Example: Using Centralized Voice Mail with Common Extension Numbering
Extn. 204
Extn. 305
Extn. 102
Extn. 101
PBX-1
Extn. 304
Extn. 203
PBX-2
Extn. 301
Private IP
Network
Extn. 103
PBX-3
Unified
Messaging
Extn. 800
[Explanation]
In this example, only PBX-1 has an extension beginning with "8" assigned (for the Unified Messaging system).
In the Flexible Numbering Plan for PBX-2 and PBX-3, "1", "2", and "3" must be set as "Extension Numbers",
and "8" must be set as an "Other PBX Extension Number (TIE)".
PC Programming Manual References
9.31 PBX Configuration—[1-3] Configuration—Option— New Card Installation—ISDN Standard Mode for
PRI23 Card
17.1 PBX Configuration
—[9-1] Private Network—TIE Table—Enhanced QSIG
17.2 PBX Configuration—[9-2] Private Network—Network Data Transmission
→
Network MSW Data Transmission for Centralized VM Feature—Data Re-transmission : Repeat
Counter
→ Network MSW Data Transmission for Centralized VM Feature—Data
Re-transmission : Repeat Timer
17.5 PBX Configuration—[9-5] Private Network—Centralized UM/VM Unit
19.1 PBX Configuration—[11-1] Maintenance—Main—Maintenance
→
Error Log for Centralized VM—Network MSW Transmission (Counter)
→ Error Log for Centralized VM—Network MSW Transmission (Buffer)
Feature Manual References
15.1.12 PRIVATE NETWORK FEATURES
15.1.14 Private Network Features
—NDSS (Network Direct Station
Selection)
Description
When PBXs are networked using ISDN or V-IPGW cards, it is possible to assign flexible buttons as Network
Direct Station Selection (NDSS) buttons. These buttons are used to monitor the status of extensions connected
to up to seven other PBXs in the network, and to make or transfer calls to those extensions with one touch,
Document Version 2016-03 Feature Manual 299
15.1.14 Private Network Features—NDSS (Network Direct Station Selection)
To Next Page
Loading...
