10.6.3 PBX Configuration—[2-6-3] System—Numbering Plan—B/NA DND Call Feature— Automatic
Callback Busy
Operating Manual References
1.3.4 Automatic Callback Busy (Camp-on)
2.1.5 Automatic Extension Release
Description
After going off-hook, if an extension user fails to dial any digits within a preprogrammed time period, the user
will hear a reorder tone. This operation applies to intercom calls only.
This feature is also known as Automatic Station Release.
Conditions
• A proprietary telephone
(PT)/portable station (PS) user hears a reorder tone for a preprogrammed time
period, and then the PT/PS returns to idle status automatically. A single line telephone (SLT) user will hear
a reorder tone until he or she goes on-hook.
• This feature works in one of the following cases:
When making an intercom call
a. The first digit is not dialed within a preprogrammed time period.
b. A digit is dialed, but subsequent digits are not dialed within a preprogrammed time period.
PC Programming Manual References
6.13 Tool—UT Option Setting
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone
→
Dial—Extension First Digit
→ Dial—Extension Inter-digit
→ Tone Length—Reorder Tone for PT Handset
→ Tone Length—Reorder Tone for PT Hands-free
2.1.6 Automatic Fax Transfer
Description
The PBX can distinguish between fax calls and other types of calls arriving on DISA lines, and automatically
transfer fax calls to preprogrammed destinations. When a call arrives on a DISA line, an OGM is played
(®
14.1.2 OGM (Outgoing Message)). At the same time, the PBX begins fax signal detection. If a fax signal is
detected, the PBX recognizes that the call is a fax call, and transfers the call to the fax destination assigned
to that OGM through system programming. This allows a single CO line to be used seamlessly for both voice
and fax calls, with only voice calls arriving at user extensions.
[Available Automatic Fax Transfer Destinations]
Destination Availability
Wired Extension (PT/SLT/T1-OPX)
ü
PS
ü
*1
Document Version 2016-03 Feature Manual 29
2.1.6 Automatic Fax Transfer
To Next Page
Loading...
