Panasonic KX-NS1000 - 2.11 Conversation Features; 2.11.1 Hands-free Operation

10.6.3 PBX Configuration—[2-6-3] System—Numbering Plan—B/NA DND Call Feature
Feature Manual References
15.1.24 PS (Portable Station)
23.1 Capacity of System Resources
Operating Manual References
5.3.1 Feature Number Table
7.1.5 Floating Extension
Description
Virtual extension numbers can be assigned to resources to make them as easily accessible as extensions.
These numbers are referred to as "floating extension numbers
" and can be assigned as a destination of
incoming calls, intercepted calls, etc.
This feature is also known as Floating Station.
Resource Description Default
Device External Pager Used as the destination for the Trunk Answer
From Any Station (TAFAS) feature. (®
19.1.1 TAFAS (Trunk Answer From Any
Station))
600 or 6000
*1
Outgoing Message
(OGM)
Used to play messages for callers via the
Direct
Inward System Access (DISA) feature.
(® 5.1.10 DISA (Direct Inward System
Access))
536–599 or 58
+ two-digit
OGM number
*1
Group Incoming Call
Distribution (ICD)
Group
Used to call an ICD group. (® 10.1.1 ICD
GROUP FEATURES)
6 or 60 +
two-digit group
number
*1*2
PS Ring Group
Used to call a PS ring group. (®
15.1.27 PS—Ring Group)
—
VM (DPT) Group Used to call a VM (DPT) group.
—
VM (DTMF) Group Used to call a VM (DTMF) group.
—
UM Group Used to call a UM group. 500 or 5000
*1*3
*1
The default floating extension number depends on the value specified for Numbering Plan in Easy Setup.
*2
A default floating extension number is provided only up to group 64. The floating extension number for groups 65 and higher must
be set explicitly.
*3
In a One-look network (® 14.1.4 One-look Network), 500 is the default floating extension number of the Master Unit's UM group.
For a Slave Unit, the default depends on the order in which the Slave Unit was registered.
Conditions
• Certain resources which are assigned a floating extension number can also be assigned a name.
Document Version 2016-03 Feature Manual 149
7.1.5 Floating Extension