Feature Default
Message Waiting set
*1
4
Call Monitor
*1
5
Automatic Callback Busy 6
Alternate Calling—Ring/Voice
*1
SIP extensions cannot perform DND Override, Executive Busy Override, Message Waiting, or Call Monitor but can be the
recipient of them.
*2
To use Call Waiting/DND Override, both
"1" and "2" are available by default.
3. Fixed Numbering (available while dialing or talking)
Features which are available while dialing or talking have fixed numbers, as shown in the following table:
[Fixed Numbering Table (available while dialing or talking)]
Feature Fixed Numbering
Pulse to Tone Conversion
Conference
*1
3
Door Open
*2
5
*1
SIP extensions cannot establish conferences but can participate in them.
*2
SIP extension users can use these feature numbers.
Conditions
• The
following are examples of feature number conflicts: 1 and 11, 0 and 00, 2 and 21, 10 and 101, 32 and
321, etc.
• Feature number + Additional number (Parameter)
Certain flexible feature numbers require additional digits to make the feature active. For example, to set
Call Waiting, the feature number for "Call Waiting" must be followed by "1" and to cancel it, the same feature
number should be followed by "0".
• Rotary single line telephone (SLT) users cannot dial feature numbers which include "
" or "#".
• Portable station (PS) users cannot use the following features:
– Personal Speed Dialing
– OGM playback/record
– S-CO Line Access
– Parallel Telephone Mode set/cancel
– Walking Extension
– BGM set/cancel
– Timed Reminder
PC Programming Manual References
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan
—Main
→Extension
→Features
→Other PBX Extension
10.6.2 PBX Configuration—[2-6-2] System—Numbering Plan—Quick Dial
148 Feature Manual Document Version 2016-03
7.1.4 Flexible Numbering/Fixed Numbering
To Next Page
Loading...
